01 / 11
Housing
Two shells of heat-resistant plastic, split down the middle and screwed shut around everything else. The barrel is the air duct; the handle carries the power.
02 / 11
Cord & strain relief
A two-core cord with a ribbed rubber sleeve where it enters the handle. The sleeve spreads each bend over a few centimetres, so the copper doesn’t fatigue at one point, which is the classic way old dryers fail.
03 / 11
Switches
The slide switch picks heat and speed by sending current through more or less of the element. The cool-shot button opens only the heater circuit, so the fan keeps blowing cold air.
04 / 11
Motor
Usually a small DC motor fed by a four-diode bridge rectifier, with part of the heating coil dropping mains voltage to what the motor needs. Salon dryers use AC or brushless motors instead.
05 / 11
Fan
A plastic impeller on the motor shaft. It pulls air in at the back and pushes it forward down the barrel. A dryer moves air first and heats it second.
06 / 11
Intake & filter
The rear grille and a removable mesh keep hair and lint out of the fan. A clogged filter starves the airflow, and the heater runs hotter than it should.
07 / 11
Heating element
Nichrome wire coiled around a cross of mica board. Nichrome resists current and doesn’t oxidise at red heat; mica insulates and survives it. Most of the 1,000–2,000 W ends up here.
08 / 11
Thermal safety
A bimetal thermostat bends open when the barrel overheats and closes again as it cools. Behind it, a one-shot thermal fuse cuts power for good if the thermostat ever fails.
09 / 11
Concentrator
A tapered nozzle that squeezes the outlet into a flat, faster jet for directed styling. The front grille keeps fingers away from the coil.
10 / 11
Airflow
Back to front: in through the filter, pushed by the fan, past the motor, over the coils, out through the nozzle.
11 / 11
Assembled
Nine parts, one line weight. Everything is there because the air needs it, and nothing is there for show.